Honda CT90, CT200 & CT110 Rear Fender Blinker Hole Plug Set - 3D Printed

Description

This is for a set of six (6) 3D printed plugs to use to plug the turn signal mounting holes on the rear fender of a CT200, CT90 or CT110
These are my 3D designs that I made to replace Honda part number 33665-053-000 and 33666-053-000
A normal installation on a bike without a spare gas tank would be two of the longer plugs and two round plugs, with a third round plug and the special half plug not needed
On a bike with a spare gas tank installed the standard installation would be three round plugs, or you can use just two round plugs and my one special half plug that would install in the two holes under the right side of the gas tank bracket.
These are made using SainSmart TPU 3D filament that is flexible, but not as soft and flexible as the rubber used in the original parts made by Honda.
These make a good functional substitute for the original parts to fill the mounting holes on your rear fender.
These fit CT200, CT90 and CT110 bikes from 1964 through 1983
This is for the set of six (6) plugs only and the bike in the pictures is for
demonstration
purposes only.